Summary
T30I (GD30K2-12) type axial flow fan is modified on the basis of FBZ-11 type axial fan. Can replace the CZL11 type long axis flow fan. The utility model can be used as a part of the pipeline, and is connected with the middle part of the pipeline, and is suitable for the harmful gases in the chemical system, the paper industry and other industries to transport various mediums below 60 DEG C.
GD30K2-12 type axial flow fan according to the diameter of the impeller can be divided into: No. 6, 7, 8, 9, 10, five machine, according to the performance requirements of four pieces of leaves, six pieces; installation angle: 15 degrees, 20 degrees, 25 degrees, 30 degrees angle four.
The biggest feature of this fan is:
The motor is arranged on the upper part of the air duct, the triangle belt is driven, and the adjustable motor seat plate is used for supporting the motor. The transmission group is fixed in the sealed cylinder in the central part of the air duct. Therefore, the fan can be transported by the tide and other harmful to the motor gas. The fan can be used to change the number of revolutions to achieve the purpose of changing air volume and wind pressure.
The fan is made of ordinary steel welding, if the delivery of corrosive, flammable gas can be clearly specified in the order.
Installation and maintenance
1, before installation should check whether the damaged and deformed parts are complete, all normal, complete and then install.
2, before installation should check with connecting part is loose phenomenon, the gap between the impeller and the air duct is appropriate, the rotating part is flexible, and the fixed part is abraded, check whether the foreign body such as a hair dryer, should be clear.
3, the installation should be checked before the bearing lubrication is good, such as long-term storage is not user, should replace the new grease.
4, the installation of the machine should be natural and ground, not forced connection, so as to avoid deformation.
5, after installation, should carefully check the anchor bolts are tightened, and test run.
6, the bearing operating temperature is not more than 65 DEG C, if there is a special noise or excessive vibration should be checked.
7, the equipment should be maintained, its inspection and repair period depending on the working conditions, should be regularly replaced bearing grease.