Support

How to install and use the material conveying fan reasonably?

Material conveying fans mainly rely on wind to transport scattered materials to the target, which is mainly used in wood processing enterprises such as: artificial panel factory, furniture factory and Other similar enterprises of a nature are mainly used to transport scattered materials such as wood and scattered bamboo. Reasonable installation and use of material conveying fans can save a lot of money. The human and material resources have created huge profits for the enterprise. So, what aspects should be paid attention to in the installation, use and maintenance of material conveying fans?
First of all, let's talk about the key points of fan installation and use:

1. Before the fan is installed, the foundation should be laid according to the position of the pneumatic conveying pipeline and the size of the drawing specified by the fan. This is the key to the correct installation of the fan.

2. After laying the foundation, the fan should be tested comprehensively, and the connection degree of each part of the fan should be carefully checked, the flexibility of the transmission system, etc.

Once problems are found, adjustments should be made in time.

3. Pay attention to the casing when installing. Whether the impeller is clean or not, if there is any sundries, should be cleaned in time.

4. The weight of the air outlet pipe shall not be added to the fan during installation. The connection shall be naturally matched instead of forcibly linked.

5. Manual turning during installation, check whether there is too tight or collision phenomenon, found that the problem should be solved in time, try to ensure that the problem found and solved

Synchronization to ensure that the fan is not running with a fault.

6. The trial operation of the fan is very important. When the wind is in the trial operation of the fan, the fan must be carried out in the designed pipe network. The pipe network should have a regulating valve, and the wind

When starting the machine, the valve should be properly closed until the fan runs normally before gradually opening the valve.

7. During the operation of the fan, pay attention to the sound of the fan, and control the amount of materials when conveying materials to avoid the motor overload of the fan or the overload of the fan itself.

Once abnormal sound is found, stop the machine immediately to check whether the fan is in abnormal condition.

8. Pay attention to whether there are flammable and explosive articles in the working environment of the fan, and be sure to keep away from the fan. At the same time, avoid volatile gases and flammable gases.

Oil enters the fan to avoid safety problems.

PREVIOUS：How to judge the quality of FRP fans? NEXT：What if the wind speed of the stainless steel